Hold down the spring loaded guide on the opposite side of the other door panel and swing the door until the guide is under the track.
Sliding closet door not stay on track.
Most sliding doors have a mechanism called an adjusting screw located at the bottom of the door ends.
If one side of your door is loose then it s most likely that a wheel or wheel brace is faulty.
Keep the top rollers connected.
A dirty obstructed or damaged track can make a sliding closet door jump off its track.
Take one of the doors down by lifting it and angling the bottom toward you until the rollers clear the top track then pulling it toward you.
To fix this issue first try vacuuming up debris and grime from the track with a crevice attachment.
Put down the door so that the bottom rollers are behind the track closer to the closet.
In these cases the problem is usually that the rollers at the bottom of the door have started to rub against the track.
Open and close the door a few times to make sure the guide stays inside the track.
Watch the roller on the top inside edge of the door to ensure it is centered in the upper track.
Open and close the bi fold door.
First check the alignment of your closet doors.
Lift it up so that the rollers at the bottom disconnect with the track.
Inspect the rollers and tighten them with a.
The rollers at the top can also wear down lowering the bottom of the door so that it rubs on the track.
The track has two channels that guide rollers that are attached to the top of each door that allow the doors to slide.
Pull the roller down and center it between the track if it is.
Grab the sliding door that is behind it.
Then wipe it with a damp rag.
There are two rollers for each door and they re usually made of a hard.
Wiggle the door until the pivot snaps into the hole.
Stand back five feet or so and examine the gaps on the top and bottom.
Once secure release the door.
Another sliding door behind may be creating a space constraint.
Sliding closet doors fall off tracks.