When you have the front door hanger in the opening you are ready to put the pocket door on the track.
Sliding door off the track.
The door may come completely off when you go to lower it.
Stand back five feet or so and examine the gaps on the top and bottom.
Pushing the wheels up will make it easier to.
Instead these wheels ride the track.
When you re done replacing the door is just as easy.
Insert the door s wheels into the double track inside the upper door jamb lifting it as far as it will go.
Sliding closet doors fall off tracks first check the alignment of your closet doors.
Find sliding closet door tracks track kits at lowe s today.
2 pull out the rollers and the weatherstripping gasket.
Note that the rollers of the door shown here reside up inside a.
Replacing them is easy but first you have to get the door off the track.
When you open or close the door it doesn t actually slide.
Reinstall your clean rollers.
Reinstalling sliding bypass doors the doors are usually interchangeable but you will want to start with the rear track.
The wheels are plastic and they stick or break causing the door to jam.
How to repair sliding door rollers 1 unscrew the rollers from the bottom edge of the door.
Slide the door over.
Kung fu maintenance demonstrates how to replace some wheels that are not rolling right on a patio slider door that is coming out of it s track and not rollin.
Slide the door as far as you can into the opening.
You will be able to tell the wheels are sufficiently.
Remove the door from the track.
Pull the door up from the bottom track until the wheels are out.
The back roller and hanger will push the front one out to where you can reach it.
Do this carefully you do not want to pop the back hanger off.
Angle the bottom of the door toward you while you let it down and the wheels should hook right onto the track.
Pull the bottom of the door out towards you and set it down off of the track.
Align each adjustment screw with.
In this photo you can see the large round screw head that is.
Taking the door out of the track 1.
There should be an even and uniform separation all the way along the top and bottom.
Place the door on a pair of sawhorses for easy access to the rollers on the bottom.
Once it reaches the floor check the bottom track to make sure that it s completely off.
While holding the door up pull it 4 8 in 10 20 cm towards you and then lower the door to the floor.